Replace engine oil in thermal state.
Time:
Sep 09,2024
In the process of the oil drainage, the user shall check the engine oil to see whether its color is normal and it has any foreign material so as to find out the fault hidden danger.
1-Replace engine oil in thermal state.
1. In the process of the oil drainage, the user shall check the engine oil to see whether its color is normal and it has any foreign material so as to find out the fault hidden danger.
2. After the oil has been drained off, the user shall fasten the oil drainage bolts for previous foreign material elimination and shall replace the new engine oil filter cartridge and then fill new engine oil into the engine until it reaches the upper limit of the oil gauge.
3. In order not to start the engine without any lubricating oil, the user shall use the exhaust brake or press the start button when the high pressure oil pump is in the fuel cut-off position and then start the engine and keep it in low revolution speed after idling for a moment.
4. Check the engine oil filter for any leakage. After the engine is shut for about five minutes, the user shall check and fill engine oil to the upper limit of the oil gauge.
Replace the engine oil filter cartridge
Replace the filter cartridges of the two related engine oil filters at the same time. Spread one layer of thin oil on the seal washer and then manually fasten the filter.
2-Step By Step Maintenance Of Truck Air Filter
Do not solely rely on the clogging alarm indicator to determine whether the air filter is blocked. Please do unscheduled inspection by opening the cover according to usage. The following will introduce you how to check and clean the air filter of the SHACMAN F3000 truck.
SHACMAN trucks air filterIf the clogging alarm indicator light of Air filter is on, please wipe the dust collector and remove dust from the filter element.
Pull the buckle of the air filter cover or Screw nut, remove the end cap, clean the dust inside the end cap, and wipe with a clean cloth.
Note: For the elevated air filters, mounted on the side, the cab should be turning over first.
SHACMAN truck air filter
Gently pull out the main filter element with dry compressed-air with a pressure not higher than 500 kPa blowing the net inside and outside surface of the filter element along the diagonal cross direction. It's best to blow from the inside out. Wipe the sealing end face.
It is forbidden to tap one end of the filter element on the car tire to shake off the dust inside. This method does not remove the dust totally.
Place lighting tools (such as cell phones, flashlights) into the filter element and inspect the outer surface for cracks, perforations, or other damage.
Note: It is forbidden to use cracked and perforated filter elements, otherwise it will cause abnormal engine wear.
Check the seal ring 7. If the seal ring is damaged or if there is any other damage to the filter element, it must be replaced.
3-Adjust Air Suspension Device Of Cab
The cabs of SHACMAN F3000 Heavy-duty Truck are equipped with air suspension device to improve the comfortableness of seat. It can be adjusted in proper range according to the requirements of the user. But the dumper and special truck equipped with hydraulic vibration damper can not be adjusted.
Air Suspension Device of SHACMAN F3000
The adjustment procedures of air suspension device of cab are listed as follows:
Air Suspension Device Of Cab
1. Front Suspension Leveling Valve
The leveling valve shall be installed according to the 77±5 specifications stated in the diagram to guarantee the installation distance (i.e. the distance between the center of the upper mounting hole and the center of the lower mounting hole) within the range of 290±5.
2. Rear Suspension Leveling Valve
The leveling valve shall be installed according to the 311±5 specifications stated in the diagram to guarantee the installation distance of air spring (i.e. the distance between the mounting point of the air spring and the control bar end of the leveling valve) within the range of 270±5.
Precautions:
1. There must be a certain of pressure kept in the air-reserve tank to guarantee the normal work of airbag.
2. The user can carry out adjustment according to the condition, but the adjustment shall not exceed the regulated range.
RELATED NEWS
